Next locate the recessed hex shaped hole in the bottom of the disposal.
Garbage disposal hex wrench stuck.
If the garbage disposer does not have a hex hole or if you do not have an allen wrench get a short broom and stick it into the garbage disposer.
Work it back and forth until the blockage breaks up and the blades move freely.
It is the best method for freeing up a jammed disposal.
Give it a turn.
Insert an allen wrench into the hole underneath the disposal.
It s inside a small round hole in the motor housing.
Here are some tips to solve this stuck flywheel problem.
On the bottom of your garbage disposal you will find a hex shaped opening in the center of the housing.
Pair of pliers allen wrench 1 x 2 wood.
Allen wrench will work.
Ensure that the garbage disposal is turned off.
This hex opening is attached to the drive shaft.
Turn off the disposal and unplug the unit.
At the base of most disposal units is an opening for a hex key thatlets you manually turn the blades.
Make sure that you force it down against one of the impeller blades and start rotating it manually back and forth.
If a larger object is responsible for the clog you may be able to remove it by hand.
Get the allen wrench that came with the disposal unit and place its head in the hole.
You should have gotten a wrench with your unit that fits here.
Confirm that the disposal is unplugged or the circuit breaker fuse is off.
Identify the hex socket on the center of the underside of the garbage disposal unit.
Using a garbage disposal wrench is not difficult.
Insert the hex wrench into this socket then move the wrench back and forth to free the jam or confirm that the impeller is freed.
Grab a flashlight and open up the cabinet under the sink.
Depending on the kind of unit you have you.
Do not test the garbage disposal for more than 10 seconds if it is not working properly and there is a humming sound.
If you cannot locate the wrench that came with the disposal a in.
It will be hexagonal shaped and in the center.
It s inside a small round hole in the motor housing.
If the blades don t turn with gentle pressure it s time to find an allan wrench or hex key.
Insert into the hole the hex head allen wrench that came with the disposal.
Remove the rubber catch or cover if needed and slide a hex wrench or wooden spoon into the disposal.
Unplug the unit then climb underneath the sink and find the hole on the disposal s underside.